Programming
20
8.5" Black and White Touch Panels
Serial Commands (Cont.)
GET CAL
Gets the calibra-
tion variables.
Syntax:
"GET CAL"
Example:
GET CAL
Gets the calibration variables on the touch panel.
HELLO
Verifies that serial
communication is
working properly.
Syntax:
"HELLO"
Example:
HELLO
If the communication is active and working, the response is "How are you doing?".
MOUSE
Turns on serial
mouse or other
touch devices.
Syntax:
MOUSE <mouse type>
Variables:
mouse type =
00: Mouse cursor Off
01: Microsoft
®
serial mouse/cursor On
Example:
MOUSE 01
Turns on Microsoft
®
compatible serial mouse. Refer to the
@MOU
section on page 29 for
the chart describing the BIT information and definitions.
SET CAL
Sets the calibra-
tion variables.
Syntax:
“SET CAL <X Multiplier> <X Offset> <Y Multiplier> <Y
Offset>"
Example:
SET CAL 2F 3A 2B 62
Sets the calibration values on the touch panel.
SETUP
Puts the touch
panel on the
Setup Page.
Syntax:
"SETUP"
Example:
SETUP
Flips the touch panel to the Setup page.
VER
Restores the cur-
rent version.
Syntax:
"VER"
Example:
VER
Returns the current version of the main firmware.
ZAP!
Clears all mem-
ory.
Syntax:
"ZAP!"
Example:
ZAP!
Clears all memory and erases all buttons, pages, drawings, and symbols.
Only use the ZAP! command to erase the saved data in the touch panel; data cannot be
recovered after it is erased.
