FCC Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Title 47, Part 15 (47 CFR 15) of the Federal Communications Commission (FCC) Rules and
Regulations establishes Radio Frequency (RF) emission limits for unlicensed emissions to
provide an interference-free radio frequency spectrum. Many electronic devices, including
computers, generate RF energy incidental to their intended function and are, therefore,
covered by these rules. These rules place computers and related peripheral devices into
two classes, A and B, depending upon their intended installation. Class A devices are those
that may reasonably be expected to be installed in a business or commercial environment.
Class B devices are those that may reasonably be expected to be installed in a residential
environment (personal computers, for example). The FCC requires devices in both classes to
bear a label indicating the interference potential of the device as well as additional operating
instructions for the user. A label on the device shows which class (A or B) the equipment falls
into. Class B devices have an FCC logo or FCC ID on the label. Class A devices do not have an
FCC logo or FCC ID on the label.
The DXP4 has been tested and found to comply with the limits for a Class A digital device,
as defined by Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case the user will be required to correct the interference at
their own expense.
EU Notice
•
This product complies with EMC Directive 2014/30/EU and the Low Voltage Directive
2014/35/EU. Conformity is shown by compliance with the applicable requirements of
the following documents:
•
EN 55032 (CISPR 32) (Class A) - Emissions
•
EN 55024 (IEC 61000-4-2,3,4,5,6,8,11) - Immunity
•
EN 61000-3-2 (IEC 61000-3-2) - Power Line Harmonics
•
EN 61000-3-3 (IEC 61000-3-3) - Power Line Flicker
•
EN 60950 (IEC 60950) - Product Safety
Caution:
!
This equipment is compliant with Class A of CISPR 32. In a residential environment
this equipment may cause radio interference.
Health and Safety Information
www.amulethotkey.com
|
Page 3
