Your DXP4
www.amulethotkey.com
| Page 13
2.
SPEED status LED
Status
Meaning
Off
No network connection
Amber
100 Mbit/s connection
Green
1 Gbit/s connection
White flash
BSM status indication. See
.
Table 3:
SPEED.status.LED.indication
2.3
BSM status indication
When power is applied to the Board Support Micro-controller
(BSM) or when the BSM is reset (for example, after a successful
firmware update), all LEDs simultaneously flash white (or very
pale blue) for one second.
2.4
Recessed button operations
2.4.1
While the DXP4 is starting up
•
press the button to restore the DXP4 factory settings.
2.4.2 When the DXP4 is powered up
•
A quick press of the button (less than one second)
toggles a local monitor on or off (Active Thermal
Solution only).
•
A long press (hold the button for five seconds or more)
toggles the Board Support Micro-controller (BSM)
network interface ON or OFF.
When the network interface is ON, you can update DXP4
firmware remotely by transferring a firmware package to
the BSM.
2.5
DisplayPort socket (Active Solution only)
Important!
There is no DisplayPort socket on the Passive
Thermal Solution DXP4, only on the Active Thermal Solution.
The local DisplayPort allows you to perform initial setup tasks or
troubleshoot the host computer.
Important!
Press the recessed button (see
) or unplug the
local monitor before you start a PCoIP session to a remote
zero client.
Note:
The DisplayPort video output is dual mode so you can
connect to DisplayPort or DVI-D video inputs on the monitor
using suitable cable adaptors.
2.2.3 Network ACTIVITY and network SPEED LEDs
The host card has two network LEDs, ACTIVITY (link) and SPEED
) on the rear panel that operate as follows:
SPEED LED
ACTIVITY LED
Figure 3:
Network.LEDs.on.the.Active.Thermal.Solution.DXP4
1.
Network ACTIVITY LED
In normal operation, this LED shows network activity and
connection type. It can also show progress for firmware updates.
NORMAL MODE
Status
Meaning
Off
No network connection
Green
Network connection full duplex; no traffic
Green blink
Network connection full duplex; traffic detected
Red wink
Fault with Teradici PCoIP: Half duplex
connection
Warning:
A half duplex connection will severely
limit a user’s experience. PCoIP sessions may
disconnect with large packet losses reported in
the PCoIP connection statistics.
White flash
BSM status indication. See
FIRMWARE UPDATE MODE
Status
Meaning
Amber
BSM network port is open and attempting to
obtain a DHCP address
Blue
BSM network port is open and has a valid IP
address (either a DHCP address or the BSM
fall-back address of 192.168.1.75)
Blue wink
BSM update is complete. The BSM network
port is closed. Restart the host computer at a
convenient time to apply the new firmware
Red wink
BSM update failed to complete (the checksum
validation failed). The BSM network port
is closed. Restart the host computer at a
convenient time to flush the new firmware from
flash memory
White
BSM status indication. See
Table 2:
ACTIVITY.(PCoIP).status.LED.indication
