AMT Datasouth Fastmark 400 Series, User Manual, Page: 18 / 76

User's Guide 17
8. Pull out 6 inches of media and thread the end of the media between the Right and Left Media
Guides.
9. Slide in the Right Media Guide until it is snug with the media.
Note: If the guides are positioned incorrectly, the media sensor may not sense
the form properly.
If too loose the media may slide out from under them, uncover the
paper out sensor and indicate a false paper out message.
If too tight so that the media may buckle and a paper jam could
occur.
10. Thread the media over the roller until approximately 2 inches of the media shows out of the
printer. (MAKE SURE THAT THE LABELS ARE FACING UP.)
11. Press the printhead module down firmly until it snaps into place.
12. Close the top cover.
13. Turn on the printer.
14. If you are using die-cut media, press the ”FEED” button to advance the first label into the
standby position.
Note: If the labels do not feed correctly, run the Label Sensor Calibration test (see the
section on Label Sensor Calibration).
Note: The first time media is loaded, the label sensor must be calibrated. After this initial
calibration, further calibration is not needed unless the media length, media changes
or irregular feeding occurs. See Label Sensor Calibration for instructions on how to
calibrate the Label sensor.