Ampcontrol VAA, User Manual

Page: 24 / 81

VOICECOM USER MANUAL ISSUE 4
-22-
VAA addressing procedure
:
1. From the VCA’s Main Status page, arrow down to the Line Status page for the line that the VAA unit is
connected to (LINE 1 or LINE 2). Note from the menu structure diagram that the first page below the Main
Status page is the Line 1 Status page. The next page down is the Line 2 Status page. To set or change the
addresses of VAA units connected to Line 1 go to the Line 1 Status page. To set or change the addresses
of VAA units connected to Line 2 go to the Line 2 Status page.
2. Once on the desired Line Status page, press and hold the key and press the key to enter
the VAA Address Setup page. This is shown in Figure 15.
NOTE: VAA address programming will time out after 10 seconds of inactivity and the display will revert back
to the Line Status page. A
** time out**
message will appear on the third line when the display is
about to time out. Continually pressing the key will reset the 10 second timer and stop the address
setup display from timing out.
3. From the Address Setup page you can cycle through all the connected VAA units by pressing the
key. The VAA units will appear starting with the unit with the lowest serial number. VAA serial number 0100
will be used in this example. Once you have found the serial number of the VAA that you want to change
the address of, press the

key once. You will notice on the second line of the display the text will change
from “Accept” to “SetAdr”, as shown in Figure 16.
4. Press the

key again and the address will increment up by one. Continue this until you have reached the
desired address value, address 4 in this example.
5. To save the address press the key.
ESC
ENTER
FUNC .............................................................................
ENTER
ENTER
Figure 15 - Entering VAA Address Setup Page
2 L1 Address Setup
SetAdr:Ent < [esc] >
S/n: 0100 Adr [ 1] 2 L1 Address Setup
SetAdr:Ent < [esc] >
S/n: 0100 Adr [ 1]
Figure 16 – Locating the VAA to address by serial number
2 L1 Address Setup
Accept :Ent < [esc] >
S/n: 0100 Adr [ 1]
2 L1 Address Setup
SetAdr :Ent < [esc] >
S/n: 0100 Adr [ 4]
Figure 17 - Setting the VAA address value
2 L1 Address Setup
SetUp :Ent < [esc] >
S/n: 0100 Adr [ 1]
2 L1 Address Setup
Accept :Ent < [esc] >
S/n: 0100 Adr [ 1]
ENTER
Figure 18 - Saving the VAA address
2 Line 1 [ 1] VAA’s
PSW RQ o/o OPo/o
----- ----- -----
----- ----- ----- - 2 L1 Address Setup
Accept:Ent < [esc] >
S/n: 0100 Adr [ 1]
ESC ENTER
+
Line 1 Status Page VAA Address Setup Page