Ampcontrol gasguard, Installation, Operation & Maintenance Manual

Page: 31 / 79

GASGUARD IS CONTROLLER Issue: R2, Date: 26/09/2011, CRN: 7502
Page 30
4.6.6 Set Tag Name 1
1. To modify ‘TN1’ press the

key to enter
2. Use the

key to scroll through the alpha-numerals
3. Use the

key to move the cursor across to the next digit
4. To save, use the

key
5. To escape, use the

key
4.6.7 Set Tag Name 2
1. To modify ‘TN2’ press the

key to enter
2. Use the

key to scroll through the alpha-numerals
3. Use the

key to move the cursor across to the next digit
4. To save, use the

key
5. To escape, use the

key
4.6.8 Change Configuration Password
1. To modify ‘Change Pass’ press the

key to enter
2. Use the

key to scroll through the numbers
3. To save, use the

key
4. To escape, use the

key
4.6.9 Change Fault Clear Setting
1. To modify ‘Change FLT CLR’ press the

key to enter
2. Use the

key to toggle between Enabled and DIsabled
3. To save, use the

key
4. To escape, use the

key
4.7 Calibration Menu
4.7.1 To Enter the Calibration Menu:
1. From the Monitoring Screen, press the

key twice to scroll up to level 6 ‘Calibration View and Modify’
2. Press the

key to enter into the ‘Do you want to Continue?’ screen
3. If YES, press the

key to gain access, if NO, press use the

key to escape
4. On the ’Enter Password’ screen, use the

key to scroll through the numbers
5. Then use the

key to move the cursor to the next digit
6. Once the password has been entered, press the

key to access a second password entry screen
7. Repeat the above steps to enter the password. Press the

to enter the ‘Calibration Menu’
To view and modify the Calibration settings use the following procedure. There are eight Levels in the Calibration
Menu. These levels allow the programmer to calibrate the four channels, three outputs and the supply voltage.
To perform a supply voltage calibration, it will be necessary to connect a
variable 10-16 Vdc power source.