3.1
FIRST USE OF THE UNIT
2.4
DMX 512 OUTPUT/INPUT CONNECTION
Make sure you are using shielded twisted cables suitable for the transmission of the
DMX 512 signal with connectors of good quality and connection as shown on the
side of the connector.
Plug the 5-pin XLR connector coming from the unit completly in the DMX 512 output
Use the “push” safety hook to disconnect it and than extract it gently.
ATTENTION: the shielded part of the cable must never be connected to the ground of
the electrical system as this could cause faults during the working of the controller
5
2.5
EXAMPLE OF DMX 512 LINE CONNECTION
MATRIX
has a
DMX 512
input/output that uses standard
XLR 5-pin
connector The
input it is for now disabled from the software.
The cable must have shielded with these characteristics:
- 2 conductors plus screen
- 120 Ohm impedance
- low capacity
- maximum transmission rate 250 Kbaud.
For the connection do reference to the figure.
M
MA
AT
TR
RIIX
X is a universal DMX controller and is provided with an initial generic configuration.
For a correct operation Y
YO
OU
U M
MU
US
ST
T configure the controller with the type of projec-
tors/scanner connected to it.
The
SETUP LIBRARY
sheet includes the list of the projectors/scanner contained in
the internal memory of the controller, if the requested configuration is not present
in the library, you need to make a personalized one.
The operations to configure the controller is described in the user’s manual at
chapter:
10.7
Function
MENU: EDIT DMX PATCH
M
MA
AT
TR
RIIX
X is endowed with graphic display with adjustable contrast from menù, if the
initial setting isn’t correct, it is possible to change the contrast.
The operations to
change contrast
is described in the user’s manual at chapter:
10.14
Function
MENU: SYSTEM SETTINGS
1
5
3
4
2
XLR 5-pin
Common
- DMX OUT
+ DMX OUT
- DMX IN
+ DMX IN
GB
Distribuited by:
AMLUX s.r.l.
46042 Castel Goffredo (MN)
[email protected] - www.amlux.it
