4
Safety|Potential Hazards
Doc P/N: 9040962 | Rev 06 | Printed 17 August 2017
Navigation pane
Potential Hazards
The CONNEX ProSight HD transmitter and HD receiver contain HD wireless video module devices that should be operated according to the same
rules and limitations applicable to normal HD wireless video module devices. Do not operate the units in environments that may be susceptible to
radio interference resulting in danger, specifically:
•
Areas where prohibited by law –
follow any special rules and regulations and obey all signs and notices. Always ensure that the unit is
turned off (the LED is not lit) when instructed to do so or whenever it may cause interference or danger.
•
Where an explosive atmosphere may be present –
do not operate the CONNEX ProSight unit in any area where a potentially
explosive atmosphere may exist. Sparks in such areas could cause an explosion or fire, resulting in bodily injury or even death. Be aware
and comply with all signs and instructions.
•
It is inadvisable to operate the CONNEX ProSight unit while at a refueling point or service station –
users are reminded to
observe restrictions on the use of radio equipment in fuel depots (fuel storage and distribution areas), chemical plants or where blasting
operations are in progress.
•
Areas with a potentially explosive atmosphere are often, but not always, clearly marked –
potential locations can include gas
stations, below deck on boats, chemical transfer or storage facilities, vehicles using liquefied petroleum gas (such as propane or butane),
areas where the air contains chemicals or particles (such as grain, dust or metal powders), and any other area where it would normally
be advisable to turn off a vehicle’s engine.
•
Near medical and life support equipment –
do not operate the CONNEX ProSight unit in any area where medical equipment
or life support equipment is in use, or near any equipment that may be susceptible to any form of radio interference. As the CONNEX ProSight
unit may transmit signals that could interfere with this equipment, the host communications device must be turned off in such areas.
For more information, visit
CONNEX ProSight Installation and Operation Guide
