28
VI. OPERATION INSTRUCTIONS
To lift vehicle
1.
Keep clean of environment near the lift.
2.
Drive vehicle to the platform and put on the brake.
3.
Take off the drive-in ramp, install rear wheel stop plates to the drive-in ramp
position.
4.
Turn on the power and press the control button, raise the lift to the working position.
Note: make sure the vehicle is steady when the lift is raised.
5.
Press the release valve handle to lock the lift in the safety position. Make sure the
safety device is locked at the same height.
To lower vehicle
1. Be sure the clearance of around and under the lift, only leaving operator in lift area.
2. Press the control button, the lift will be raised for 3-5 seconds, and then press the
safety release handle, make sure the safety device released, press the release valve
handle by the other hand, then the lift starts being lowered automatically.
3. Drive away the vehicle when the lift is lowered to the lowest position. Take off the
rear wheel stop plates and install drive-in ramp, then left the lift.
4. Turn off the power.
VII. MAINTENANCE SCHEDULE
Monthly:
1.
Lubricate cable with lubricant;
2.
Check all cable connection, bolts and pins to insure proper mounting;
3.
Make a visual inspection of all hydraulic hoses/lines for possible wear or leakage;
4.
Lubricate all rollers, safety devices with 90wt. gear oil or equivalent.
Every six months:
1.
Make a visual inspection of all moving parts for possible wear, interference or
damage.
2.
Check and adjust as necessary, equalizer tension to insure level lifting.
3.
Check columns for plumbness.
Summary of Contents for 408-P
