7
D. Install the Safety Ladders.
1. Take off the pulley safety cover and unscrew a nut of the safety ladders, and then
adjust the four lower nuts to be at the same position. Then install the safety ladder
(See Fig. 13).
2. Install Safety Ladders
(See Fig. 14).
This height should
be the same for
four safety ladders
Safety ladder pass through the hole of
the top plate, then tighten the two nuts
Fig. 14
Fig. 13
Safety Ladder is inserted between
Limited Pins of the cross-beam
Safety Ladder
Limited Pin
Limited Pin
Unscrew A nut of the
safety ladders
18
17
Take off the cross
beam plastic cover
Insert the safety ladder
from up to the bottom
between the Limited Pins
Summary of Contents for 408-P
