42
3. Bleeding air
This hydraulic system is designed to bleeding air by loosing
the bleeding plug. Lifting the carriages to about 1 meter
height, and loose the bleeding plug, the air would be
bled automatically, then tighten the plug after bleeding,
the lift would work stably and smoothly,
otherwise repeat bleeding
(See Fig. 55)
.
4. Adjust the lower speed
You can adjust the lower speed of the lift if needing: turn the throttle valve clockwise
to decrease the lower speed, or counterclockwise to increase the lower speed.
5. Test with loading
After finishing the above adjustment, test running the lift with loading. Run the lift in
low position for several times first, make sure the lift can rise and lower synchronously,
the Safety Device can lock and release synchronously. And then test run the lift to the
top completely. If there are anything improper, repeat the above adjustment.
Fig. 55
Fig. 56
Bleeding plug
Throttle valve
Throttle valve
Clockwise to decrease the lowering
speed
Counterclockwise to increase the
lowering speed
Summary of Contents for OHX-10
