12
Place the two columns in parallel on the ground of the installation position, and
determine the installation position of the power-side column according to the
condition of the installation site. Under normal circumstances, the power-side
column is installed on the right side of the entering direction; when installing
the outer column, it should be installed according to the height of the workshop.
When the height is not more than 168", the mounting column is selected to
install the lower position; when the height is more than 168", the mounting
column can be installed with the high position. (See Fig.21)
Fig.21
Mounting column low
setting
Mounting column high setting
28
2
3
1
18
Summary of Contents for OHX-10
