AMG AMG-I30B Series, User Manual

Page: 13 / 54

9
Use the RS232 cable to connect the device to the computer. Connect
the corresponding end of the cable to the 9-pin serial communication
port on the computer and the other end to the RS232 communication
port on the device as shown below.
Note: Connections using the RS232 cable should not exceed 40 feet.
If the connection will be over a distance greater than 40 feet, please use RS485 or
Ethernet communication mode.
1. Press Menu Key > Setup > Communication . Set Device ID, Baud
Rate, press ESC and press OK to save changes.
2.
Power cycle device.
3. Connect the RS232 (serial) cable with one end connected to the 9-
pin communication serial port of the PC and the other to the RS232
communication interface on device.
4. Power cycle device.
RS-485 Communication Mode
1. Press Menu Key > Setup > Communication .