Revised 09/2005
E-mail: [email protected]; [email protected] ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts) ; Fax: +420 582 360 606
1- 5 4
84-55
CONTROLS & PROGRAM DESCRIPTION
parameters are not active if parameter “Type” in Screen 4.2.d1 is set ‘2’ which means Point
Collar. These parameters are active only in case of round corner. Press key
F1
to enter Screen
4.2.e4.
Needle Stop position
Up
Screen 4.2.e4
In point corner program this parameter is used to define the position of needle. It may be set to
‘Up’ or ‘Down’. Press key
F1
to enter Screen 4.2.e5.
b )
F l y B a c k F u n c t i o n ( F l y ) :
There are certain flaps where stitching needs to be avoided in between a continuous sewing
cycle. This function helps to leave that zone unstitched.
In Screen 4.2.e1, if parameter “Fun Type” is set ‘1’ that means a fly back function and pressing
key
F1
will enter into Screen 4.2.e.fb1 for fly back parameters.
f1 Back tack – Fly
In – No Out - No
Screen 4.2.e.fb 1
This screen displays Back tack selection for fly back function. In and Out selected Yes/No
define back tack required or not in entry and exit zones of a fly back function respectively. The
head motor will stop for fly back, needle will stay in up position and forward drive parameters
will remain the same as defined in Screen 4.2.e3 (f1 Drive Speed).
The back tack parameters at the time of entry will remain the same as for starting parameters of
back tack defined in Screen 4.2.d6,7 & 8 and back tack parameters at the time of exit will
remain the same as for parameters of end back tack defined in Screen 4.2.d17,18 & 19. Press
key
F1
to enter Screen 4.2.e.fb2.
In f1 Thread Trim
Time – 0.0s
Screen 4.2.e.fb 2