Ametek Sorensen XG 100-15, Operating Manual

Page: 62 / 399

Local
Operation
3-16 M370430-01 Rev F
Shipped Configuration (Local Operation)
The power supply is configured for local operation at the factory. See
Table 3-3 for a summary of this configuration. For more information on
default settings, see Table 3-9 on page 3-42.
Table 3-3 Shipped Configuration
Local Control Configuration Additional References
Use the front panel controls to
adjust the output voltage and
current set point settings.
See Chapter 3, “Local Operation” for front
panel operation. See Chapter 4, “Analog
Programming (APG) and Isolated Analog
Programming (ISOL)” for analog
programming procedures.
The OVP set point is adjusted at
the front panel to 105% above
the maximum rated output
voltage.
See “Using Over Voltage Protection (OVP)”
on page 3-27 for the adjustment procedure.
Enabling the Output
Enabling the output on will also turn off the ALARM LED if the
ALARM LED has been latched on due to an alarm triggering and
automatically clearing. See “Alarms and Errors” on page 3-20.
To enable the output power:

Press the OUTPUT ENABLE Main button on the front panel or
enter the SCPI command.
The OUTPUT ENABLE Main button will illuminate.
To disable the output power:

Press the OUTPUT ENABLE Main button when the OUTPUT
ENABLE Main button is illuminated.
The output will be disabled and the LEDs will not be illuminated.
Important:
The main output will not turn on if the shutdown function is
activated. See “Using the External Shutdown Function” on page 3-32.
Quick Tip Remote
Operation uses these
commands. See page
5-1.
The SCPI command (s) for these instructions are:
[:]OUTPut[<channel>][:POWer][:STATe]