Ametek Sorensen DLM-E, Operation Manual

Page: 24 / 74

Features and Specifications DLM-E 3kW & 4kW Series Power Supplies
1-6 M362000-01 Rev E
1.4.4 Mechanical Specifications
Unit Dimensions
Height Width Depth Weight
87.6 mm (3.5 in) 482.6 mm (19 in) 508 mm (20 in) 18.2 kg (40 lbs.)
Output Connector (Models DLM5–XXX through DLM80–XX)
Connector type: Nickel–plated copper bus bars
Approximate dimensions: 1" wide x 0.25" thick
Distance between positive and negative bus bar main mount in holes: 2.5"
Load wiring mounting holes: Two 0.312" diameter holes for securing high current output
cables. Four 0.201" diameter holes for securing lower current cables and sense leads.
Remote Sensing: Two pin screw–clamp removable mating connector housing is supplied with
each unit for remote sensing. Accommodates sense lead wire 16–22 AWG.
Output Connector (Models DLM150–XX through DLM600–XX)
Connector type: Four–position terminal block (two positive and two negative connections)
#6–32 plated Phillips head SEMS screws accommodate up to #12 AWG.
Approximate dimensions: Terminal center spacing of 0.437"
Safety: Three-sided plastic cover provided with wire exit cutouts.
Remote Sensing: Two pin screw–clamp removable mating connector housing is supplied with
each unit for remote sensing. Accommodates sense lead wire 16–22 AWG.
Input Connector
AC Input: 3–position fuse block with screw clamp connectors.
Ground: 10–32 safety ground stud on chassis located below fuse block.
Note 1: Screw clamp connectors accommodate up to AWG #6.
Note 2: Power cables not supplied.
Note 3: A clamp–on EMI filter is supplied with each power supply to allow compliance with the
Electromagnetic Compatibility Directive requirements of the European Community.
See Section 2 for proper installation.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE