Ametek ORTEC EASY-NIM 928 Suite, Hardware Manual

Page: 62 / 66

PROPERTY OF AMETEK, INC.
–
ORTEC ®
ORTEC
®
EASY-NIM
™
928 Suite 932512A / 0114
56
7 Input 6 BNC
8 Timer Interval 1
9 Timer Interval 2
10 Software Group 1 Enable
11 Software Group 2 Enable
4 Counter input Value
0 Corresponding Counter BNC Input
1 Connected to Overflow of Counter 2
2 Connected to Overflow of Counter 3
3 Connected to Overflow of Counter 4
4 Overflow of Timer 1
5 Overflow of Timer 2
6 ROI (counts all channels for which Region-of-Interest bit is set)
5 Signal threshold Range -1.6 V to 3.0 V
6 Impedance 0 = 1 kΩ, 1 = 50 kΩ
7 Counter input signal edge 0 = rising edge, 1 = falling edge
8 Auto reset 0 = off, 1 = On
9 FIFO counts Number of words in FIFO (this value is read only. Can only be used in
SHOW_COUNTER_CONFIG)
10 Acquisition status mask (Read only. Can only be used in SHOW_COUNTER_CONFIG). Bit-mapped
flags indicate whether counter or timer has started counting.
Bit 0 Counter 1
Bit 1 Counter 2
Bit 2 Counter 3
Bit 3 Counter 4
Bit 4 Timer 1
Bit 5 Timer 2
11 Alarm threshold counts per second
SET_OUTPUT_CONFIG n1, value
Set the output configuration where n1 is 1 and the corresponding output value is defined as follows:
0 Software Control
1 GND (0 V)
2 Logic high (5 V)
3 Counter 1 Overflow (Pulse)
4 Counter 2 Overflow (Pulse)
5 Counter 3 Overflow (Pulse)
6 Counter 4 Overflow (Pulse)
7 Timer 1 Overflow (Pulse)
8 Timer 2 Overflow (Pulse)
9 Counter 1 Overflow Level (must be Reset)
10 Counter 2 Overflow Level (must be Reset)
11 Counter 3 Overflow Level (must be Reset)
12 Counter 4 Overflow Level (must be Reset)
13 Timer 1 Overflow Level (must be Reset)
14 Timer 2 Overflow Level (must be Reset)
15 Timer 1 Interval
16 Timer 2 Interval
17 CRM Alarm 1
18 CRM Alarm 2