Ametek ORTEC EASY-NIM 928 Suite, Hardware Manual

Page: 50 / 66

PROPERTY OF AMETEK, INC.
–
ORTEC ®
ORTEC
®
EASY-NIM
™
928 Suite 932512A / 0114
44
CLEAR_PRESETS
The live time, true time, ROI integral, ROI peak, and overflow presets are all set to zero (disabled).
CLEAR_ROI
The region-of-interest flags for the channels in the window of interest (see SET_WINDOW command) in the
currently selected device (see SET_DEVICE command) are cleared.
DISABLE_OVERFLOW_PRESET
Disables the overflow preset. Channels that receive a count when they contain 2147483647 counts, the
maximum number of counts, will roll over to zero counts if the overflow preset is disabled. See also
ENABLE_OVERFLOW_PRESET and SHOW_OVERFLOW_PRESET.
DISABLE_TRIGGER
Disables the data acquisition trigger that was enabled by the ENABLE_TRIGGER command. Cancels an
ENABLE_TRIGGER_REP if it is issued before the acquisition starts. See ENABLE_TRIGGER, TRIGGER, and
SHOW_TRIGGER.
DISABLE_ZDT
Returns the EASYNIM 928 to normal operation if in zero-dead-time (ZDT) mode. See ENABLE_ZDT.
ENABLE_OVERFLOW_PRESET
Enables the overflow preset. Channels that receive a count when they contain 2147483647 counts, the
maximum number of counts, will stop the acquisition if the overflow preset is enabled. The channel that
caused the preset to complete will contain 2147483647 counts. See also DISABLE_OVERFLOW_PRESET and
SHOW_OVERFLOW_PRESET commands.
ENABLE_ZDT
Sets the EASYNIM 928 to ZDT mode. See SET_MODE_ZDT for information on selecting the ZDT mode.
INITIALIZE
Returns the EASYNIM 928 (including flash) to the factory default settings.
LIST_DISPLAY
Not used by the EASYNIM 928; included for backward compatibility.
LIST_GAIN_CONV
Lists legal conversion gain settings.
Response:
GAIN_CONV 512 1024 2048 4096 8192 16384
LIST_MODE_ZDT
Reports the legal ZDT-mode settings. Each item in the list can be selected by sending the SET_MODE_ZDT
command with a mode number. The mode number is implied by the location of the mode in the list. For
example, the first item in the list had a mode number of 0. To select the first item, send SET_MODE_ZDT 0.
The second item has a mode number of 1, and so on.
Response:
MODE_ZDT NORM_CORR CORR_ERR Mode 0 stores the normal and corrected spectra. Mode
1 stores the corrected and the error spectra.