128797 05
2017-08-11
12
3.4
Upper display (Read-back display)
- Functions
3.5
Lower display (Primary display) – Functions
Primary Parameters
Determine what parameter is
going to be measured.
The available options for the
upper display are: CURRENT,
VOLTAGE, SWITCH TEST,
PRESSURE and LEAK TEST.
Secondary upper display
Shows where in the preset
span the measured value
falls. Fixed for mA at 4 (0%)
and 20 (100%). Also shows
mA value for percent error,
mA or Volts value for scaling
and leak rate for pressure.
Units
Shows what unit the
measurement value is in.
Available options are : mA,
SCALING, %ERROR, VOLT
and PRESSURE UNITS.
Additional parameters
Selection and selection of
parameters relevant to the
choice of primary parameter
Primary Parameters
Determine what parameter is
going to be measured or
sourced.
The available options for the
upper display are: CURRENT,
VOLTAGE, THERMO-
COUPLE, RTD, OHMS,
FREQUENCY, PULSE,
PRESSURE and BARO (opt.)
Native Value
0 to 100 % in mA out mode
and leak rate for pressure.
Units
Shows what unit the
measurement or source
value is in.
Numeric display
Displays the numeric values
of the signal being
measured, or sourced.
An “OL” reading indicates an
out of range or overload
condition.
Input / Output
Switches / indicates lower
display input mode (read),
and output mode (source).
Numeric display
Displays the numeric values
of the signal being
measured.
An “OL” reading indicates an
out of range or overload
condition.
Backlight Intensity
Indicates Low, Medium or
High intensity on backlight
Additional parameters
Selection and selection of
parameters relevant to the
choice of primary parameter
.