PN 9000-165-VE, Rev P
Sensor (Analyzer) Name Configuration
The default name of the analyzer is WDG-n, where ‘n’ is the address of
the analyzer. If you have multiple sensors, entering a name for each
sensor you want to connect is recommended but not required.
1. From the
Main Menu
screen, press
ENTER/MENU
to access the
Configu-
ration Menu
.
2. Press the Left or Right arrows to locate the
System Name Configuration
menu and press
ENTER/MENU.
3. Use the keypad to enter the name(s) of your analyzer(s). Enter the name as
you would on a mobile phone. The keypad displays the characters as you
enter them. For example, to select the letter ‘E’ press the ‘3’ key twice. To enter
the number ‘2’ press the ‘2’ key four times (e.g., ‘A-B-C-2.’)
Maximum number of characters is 10.
4. Navigate to
ACCEPT
and press
ENTER/MENU
after each name to accept
the name of that sensor.
Figure 2-4.
Sensor (Analyzer) Name
Configuration screen.
2-6 | Thermox
®
AMEVision Display User Interface
Summary of Contents for AMEVision
