AmeriGlide STRATOS VPL, Installation & Service Manual

Page: 19 / 44

STRATOS WITH ENCLOSURE:
Install Manual
25MAR2022 | 630-00147 C
19
INSTALLATION
STRATOS WITH ENCLOSURE: SECTION 4
4. Whether the enclosure uses a fixed ramp or
you have a pit, the next step is to adjust the
height of the doors to fit their thresholds. Pry
them gently to the correct height with a piece
of wood to prevent damaging the finish. In
order to set the height correctly, you may
need to adjust the lower and upper stops on
the lift to have it stop correctly on the
landings.
Limit switches are housed inside of the tower
and are visible with the font panel removed.
They can be adjusted UP or DOWN on a
slotted channel with Allen bolts holding them
in place.
Turn power off if an adjustment is required.
WARNING !
5. Use the provided plexiglass above the door.
Install the acrylic with the angles and flats
provided, which rivet in. See Figure 4-13.
Adjust the
door to the
final position,
then cut the
plexiglass
to fit the
opening and
rivet in
Determine
required
threshold
height. If it
uses a fixed
ramp or
other, be sure
to plan for it.
Figure 4-13
6.
Adhere the Z97.1 labels on plexiglass after
installation.
NOTE: Note: Plexiglass comes cut to spec. Trim will be
provided to hold plexi in place, however it will need to be
riveted to secure. See Figure 4-14.
Figure 4-14
NOTE: Depending on the platform application you may
need to verify spacing around the platform to ensure a
clear path of travel.
7.
If the unit is equipped with a ventilation
system, power will need to be supplied
separately from the VPL unit. The ventilation
system is DC power operated but requires an
AC power supplemental charge.
NOTE: The ventilation system comes installed with
a thermostat. The thermostat is preset to meet
ASME A18.1 set the temperature under rule 2.1.1.8
(temperature not to exceed 32 ° C or 90 ° F).