5) Press
the
PROG/OK
key to confirm, wait several seconds for the Base to Reset and “Saved” is shown when
completed.
Default Base setting
Item Selection
Preset Remark
Dial mode
Tone or Pulse
Tone
Calls log record
Maximum 20 digits with
Date/Time each record
Empty
Flash time
100,120,270,300,370,600,800ms 600ms
Pin code
Any 4 digits
0000
Time
12:00a to 11:59p
12.01p
Date
Any valid date within year
2000 to 2099
Year:2006
Month:1
Date:1
CID prefix
On/Off
Off
Base Unit Status Indication
•
The Base Unit is equipped with a
CHARGE
indicator (a red LED), which is turned on by putting the Handset
in the charge cradle.
•
The second Base Unit indicator is a
Message Waiting
indicator
.
This LED is turned on when voice mail
message waiting indicator (VMWI) signal is received.
Display Messages
The Handset provides a number of on-screen status messages, both in the idle state and during conversation.
The following status messages are shown in the
idle
mode (in prioritized order):
When the Handset does not have a valid registration, the display shows:
Not Reg
When the Handset is out of range, "Searching" is shown in line one.
Searching
When another HS (registered to the same Base) is in use, the display shows:
Ext. in use
When a voice mail message waiting indicator signal is received at the base, the display shows:
Message waiting
When there is a non-answered incoming call with Caller ID information, the display shows:
Missed calls
When the handset put on the cradle, it will display "Charging":
Charging
If the battery voltage is too low to guarantee reliable use, the display shows:
Note: Message and display priority.
1. Not Reg-no registration record.
2. Searching-out of range from base.
3. Ext. in use-HS is in use.
24