American Landmaster 36V 200 Series, Service Manual

Page: 23 / 31

15312 200 Series 36V
12V Power

With ignition key “ON” check to make certain that the battery indicator and
headlights are functional.
Power Checks: 12V

If there is no 12 volt power, check the main 350 amp fuse and chassis harness fuse.

Check fuse first by looking at the piece of metal that runs through the glass. If it is
broken, replace the fuse. If it appears to be intact, confirm with the meter by setting
on the meter to “Ω” and placing a probe on each end of the fuse. The meter should
give a value close to Zero Ohms (0Ω). “OL” displayed will represent a blown fuse.

If still no power, check all connections (pins, wires, locations) same as you would for
the models with gas engines.
o
Chassis harness yellow plug (inserted fully).
o
Relay plug (Blue or Black automotive relay).
o
The dash panel harness, especially the “bullet” connectors (make sure they
are tight) and the spade connectors (make sure they are properly installed)
o
ALL pins at ALL connectors of ALL harnesses are properly installed and in
the correct positions.
o
Check all splices in the harness.

All connectors are fully inserted into the controller.

Confirm that batteries are wired correctly.

Check continuity of all wires and cables. Confirm with the meter by setting on the
meter to “Ω” and placing a probe on each end of the wire/cable. The meter should
give a value close to Zero Ohms (0Ω). “OL” displayed will represent a broken wire.
Safety Switch
Probe Placement
Open circuit with
throttle returned
Complete circuit
with throttle
pressed