American DJ
®
- www.americandj.com - Quad Scan LED Instruction Manual Page 16
American DJ
®
- www.americandj.com - Quad Scan LED Instruction Manual Page 15
Quad Scan LED 1 Channel Mode - DMX Traits
Channel Value
Function
1 SHOWS
0 - 7 BLACKOUT
8 - 22 SHOW 1
23 - 37 SHOW 2
38 - 52 SHOW 3
53 - 67 SHOW 4
68 - 82 SHOW 5
83 - 97 SHOW 6
98 - 112 SHOW 7
113 - 127 SHOW 8
128 - 142 SHOW 9
143 - 157 SHOW 10
158 - 172 SHOW 11
173 - 187 SHOW 12
188 - 202 SHOW 13
203 - 217 SHOW 14
218 - 232 SHOW 15
233 - 247 SHOW 16
248 - 255 SOUND ACTIVE SHOWS 1-16
Quad Scan LED
Operation
ENTER.
2.
Tap the UP or DOWN buttons until you find your desired show,
and press ENTER then press and hold MENU for 3 seconds to
con firm. See pages 10-11 for more info.
3. The optional UC3 Controller (not included) may be used to con-
trol different functions including blackout.
Master-Slave Operation
This function will allow you to link up to 16
units together and operate without a controller. The units will be sound
activated. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units programs. Any unit
can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit find your desired show and set that show by
pressiing the ENTER button. After you have set your desired
show,
press the MENU button until “
SLND
” is displayed, and Press
ENTER. Press the UP or DOWN buttons until “
MAST
” is displayed,
and press ENTER to confirm.
3. On the slave units
press the MENU button until “
SLND
” is dis-
played, and press ENTER. Press the UP or DOWN buttons until
either “
SL 1
” or “
SL 2
” is displayed, choose your desired slave
mode and press ENTER to confirm.
4. The slave units will now follow the Master unit.
NOTE: In a Master/Slave configuration you can set one fixture to
Master or Slave 1 (SL 1) and then set the next fixture to Slave 2 (SL
2), in doing this the fixtures will now have contrast movement to each
other.
Quad Scan LED UC3 Control
Blackout Blackout the unit
Function
1.White LED Strobe
2.White LED Strobe by sound
3. Multicolor Strobe by sound
Select Show
(Show 1-16)
Mode
Sound/Strobe
(LED ON)
Show
(LED Blinking)
