American DJ
®
- www.americandjeurope.com - Dura Spot 150™ Instruction Manual Page 12
Dura Spot 150™
System Menu
On-Board System Menu.
To access these menus you must press
the ESC button twice and then press the UP button until you find the
specific menu you are looking for.
A001 -
DMX Address Setting
via control board -
1. Access the main menu.
2. Tap the ESC button until “
ADDR
” is displayed, press ENTER.
3. Now the display will show “
A001
”. Adjust the DMX address
by pressing the UP or DOWN buttons.
4. Press ENTER to confirm.
5. Press the ESC button to return to the main menu.
TEST
- This will test the functions of this light.
1. Access the main menu.
2. Tap the ESC button until “
TEST
” is displayed, press ENTER.
3. The display will show “
Mo
d
1
”. You can now press the up
button to change between the three different modes.
4. Press ESC to exit.
AUDI
- This function is the Sound Active mode.
1. Press the ESCAPE (ESC) button until “
A.001
” is displayed.
Then press the UP button until “
AUDI
” is displayed. Press the
ENTER button.
2. Press the UP button to display “
YES
”. Press ENTER to con-
firm.
3. You can adjust the audio sensitivity of the unit by turning the
audio sensitivity knob clockwise, located in the rear.
Note: When the unit is in Sound Active mode, “test run” will
continuously flash on the LCD screen.
American DJ
®
- www.americandjeurope.com - Dura Spot 150™ Instruction Manual Page 17
Dura Spot 150™
Operation
this mode when running a single unit, or when running several units as
individuals.
SOUND ACTIVE MODE:
1. To activate Sound Active mode, press the ESC button twice until
“
TEST
” is displayed. Now press the Up button until the L.E.D. dis-
plays “
AUDI
”, press Enter. Press the Up button until “ON” is dis-
played. If “ON” is already displayed then press Enter. Now press
the ESC button.
2. You can now press the Up button to access the speed menu for
the pan/tilt. Once you access the speed menu you can press the
Up or Down buttons to change the speed. The higher the value
the faster the speed.The unit will react to the low frequencies of
music via the internal microphone.
3. Adjust the audio sensitivity knob on the bottom of the unit to make
the unit more or less sensitive to sound. Turning the sensitivity knob
in the clockwise direction will increase the sensitivity, turning the
knob in the counter-clockwise direction will decrease the fixture’s
sensitivity to sound.
4. The optional E122/C Controller may be used with this mode to
control blackout.
TEST MODE:
When power is supplied to the unit this is the default setting. Press
ESC once to select from three different modes.
1. To reactivate a Test mode, press the ESC button twice. The LCD
will display “
TEST
”, press Enter. You now have three test programs
(modes) to choose from. Press the Up button or Down button to
find the program that you want to activate. When you have found
your desired program press Enter.
2. You can now press the Up button to access the speed menu for
the pan/tilt. Once you access the speed menu you can press the
Up or Down buttons to change the speed. The higher the value
the faster the speed.
3. Now press the ESC button. The unit will react to the low frequen-
cies of music via the internal microphone.
4. The optional E122/C Controller may be used with this mode to
control blackout.
Master-Slave Operation (Sound Active or Test Mode):
This
