• 4 GB of DDR4 programmable logic (PL) memory
• 2 GB of DDR4 processor system (PS) memory
• MSP432-based satellite controller (SC) for card monitoring and telemetry
• PCIe Gen 3 x16 or Gen 4 x8 bifurcated host interface
• Low profile (HHHL) single slot (111.15 mm x 167.65 mm) form factor with a 60W power
envelope
• DMB II maintenance and debug port for card maintenance and developer support functions
Note: The proprietary DMB II interface requires a Xilinx ADK dongle.
Software Overview
The T2 card has a factory image installed that together with the provided host software
installation supports the following functions:
• PCIe Gen3 x16 interface
• User flash image update
• SC firmware update
• DDR4 PL BERT performance and diagnostics test
• DDR4 PS BERT performance and diagnostics test
• PCIe performance and diagnostics test
• In-band telemetry
Zynq Ult RFSoC Specification
The Zynq Ult RFSoC device on the T2 card is a XCZU48DR-2FSVG1517E. A comparison
of the features of this device relative to other devices in the same family is shown in the
following figure. Refer to the Zynq
®
for further
details.
Chapter 1: Introduction
UG1496 (v1.0) June 15, 2022
T2 Telco Accelerator Card User Guide
5
