26
Installation
15.0 Glass Door Installation
WARNING:
Do not operate appliance with the glass front cracked or broken. Replacement of the glass should be done by a licensed
or qualified service person. Do not attempt to remove the glass door when the appliance is hot. Be sure there are no
fingerprints left on the glass panels during install or when cleaning as high temperatures can bake these prints on
permanently. Inspect the door gasket to ensure no damage has occurred when installing the door.
15.1 If Your Glass Breaks
If the glass door should crack or break, replace the original door assembly with the manufacturer's door assembly
(part number: URP-890-0000).
•
Remove the barrier screen (see
Section 14.0
)
•
Remove the door as described above
•
Replace the door assembly
•
Reinstall the barrier screen
Note:
the NEW door will emit an odor when the appliance is lit. The odor will dissipate after the gasket material within the door has
cured.
Warning:
Only door certified with the appliance shall be used. Do not use substitute glazing materials.
Step 1:
Hold the glass door at an angle so that the edge on the bottom of the door engages with the lower spring relief. See
Figure
15.0.01
.
Step 2:
Rotate the top of the door upward.
Step 3:
Rotate both door buckle release handles outward. Pull
forward latching the door spring hook over the door hook.
Figure 15.0.01:
Figure 15.0.02:
Figure 15.0.03:
Note:
These tabs ensure the door is
centered on the fireplace.
Summary of Contents for Inspiration 29
Page 66: ...NOTES...
Page 68: ......