Commissioning
ZG-TS BAG0203.2 06.19
61
6.6.1
Settings for border spreading
See the setting chart for the values for boundary spreading the ap-
propriate fertiliser and enter them in the Fertiliser menu of the ISO-
BUS software:
•
Select TS border spreading vane
(A, A+, B, C, D).
•
Set TS border spreading vane (1, 2, 3)
0 – do not mount a telescope
•
X
– Perform border spreading with normal spreading vanes.
Border spreading is not switched on with the operating terminal
(without TS)
→
Do not switch ClickTS to the boundary spreading position.
•
PTO shaft drive: reduce r.p.m.
Hydro: On the boundary side, the quantity and spreading vane r.p.m.
(Hydro) are reduced automatically.
Setting the TS border spreading vane on the long spreading vane on
the right / left depends on:
•
boundary clearance,
•
type of fertilizer
The value to be set should be read from the setting chart.
•
The values in the setting table are intended as guideline values,
since fertiliser condition may differ.
•
The border distance on the setting chart basically represents
half the working width.
