Start-up
UX01 Super CP Plus BAG0229.2 11.21
141
8.5
Installing the wheels
To assemble the wheels, use:
(1) conical rings in front of the wheel nuts.
(2) only rims with a fitting countersink for the conical ring.
If the implement is equipped with emergency wheels, the running
wheels must be installed before initial operation.
WARNING
The wheel rims that fit on the tyres must have a rim that has
been fully welded all the way round!
A extension for the hydraulic jack and ladder must be installed when
tyres with a diameter greater than 1860 mm are used.
1. Lift the implement slightly using a lifting crane.
DANGER
Use the marked attachment points for the slings.
See also "Loading" section, page 40.
2. Loosen the wheel nuts of the emergency wheels.
3. Remove the emergency wheels.
CAUTION
Be careful when removing the emergency wheels and putting on
the running wheels!
Required tightening torque for wheel nuts: 510 Nm.
