Amate Audio DSP608, User Manual

Page: 5 / 26

DSP608
– DSP608D
Jan 2017
5
Amate Audio
G) Rotary Thumb Wheel
– Turn the wheel to change parameter data values. Click
on it to confirm the value entered. The center click of the wheel is also use to
browse different parameters of the same feature.
H)
Output signal LEDs - Show the current level of the output Signal: Signal (-
48dBu), -6dBu, Limit (orange), Clip (red). The Limit led lights up if a gain
reduction is taking place (due to a programmed compressor). The Clip LED
indicates a gain this reduction is higher than 12dB.
3.2 The rear panel
DSP
608
DSP 608D
A)
Power switch - Controls power On/Off.
B)
Main Power - Connects via a standard IEC socket. A compatible power cord is
supplied with the unit. The input voltage range is 85 to 240VAC, 50-60Hz.
C)
XLR input and outputs - Separate 3-pin XLR connectors are provided for each
audio input and output. The device's output stage employs the balanced
impedance topology. All I/O connectors have pin 1 as ground (shield), pin 2 as +
and pin 3 as -.
D) Ethernet port
– RJ45 connector to connect with the PC via Ethernet. Use CAT-5
or CAT-6 cable. In DSP 608D, this connector is also the input port for the two
available Dante® Inputs.
E)
AES/EBU Input
– This XLR connector accepts a 2-channel digital input in
AES/EBU or S/PDIF format, 16 or 24-bit. Supported sample rates are 44.1, 48,
88.2 and 96 kHz.
E
B C
C
A
D