Amate Audio DSP608, User Manual

Page: 6 / 26

DSP608
– DSP608D
Jan 2017
6
Amate Audio
4 QUICK INSTALLATION
4.1 Before you start
Before powering up the unit, make sure that the input and output XLR cables are in
good state and following the following pinning diagram: 1 for shield, 2 for live(+), 3
for return (-) as defined by the AES14 standard.
Do not connect the unit to your computer before installing the software and the USB
Driver. Please refer to installation instructions in this manual.
When connecting the DSP to the amplifiers, mute the DSP outputs (or turn down the
amplifier’s volume knobs) until you configure your processing. Loudspeakers may be
damaged due to a wrong setup. It is advisable to unmute first the high frequency
channels: in case they are connected to low frequency drivers by mistake, they
cannot be damaged. Otherwise, high frequency speakers may be damaged because
of trying to reproduce low frequencies.
4.2 Power Up
After powering up the unit, all LEDs will be lit for about six seconds, while the
following message is displayed on the LCD:
After that, the DSP unit displays its main screen:
Now the DSP
unit is ready to operate. The screen shows the name of the unit (above
line) and the program name currently active (below line). The program assigned is
always the last program the user recalled or stored before powering down the unit.
An admiration mark (!) beside the program name means that the program has been
modified but not stored. This symbol does not appear when the modified program is
the default preset.
4.3 1 Control Software
The DSP units are shipped with a Computer Software which provides a Graphic
User Interface (GUI) application - DSPLink. DSPLink allows the user to control the
DSP unit from a computer via the USB communication link or through Ethernet, in
models. For the USB connection, a driver must be installed (included with the
DSPLink installation package).
Initialising...
DEFAULT PRESET
AMATE AUDIO
! My_Preset
AMATE AUDIO