DSP608
– DSP608D
Jan 2017
14
Amate Audio
•
Att.
- Attack time. Time it takes the compressor to start actuating after reaching the
threshold.
•
Hold
- Hold time. Sets up a delay before the compressor enters the release cycle.
Useful for compressing low frequency long notes.
•
Rel.
- Release time. Time the compressor uses to return to unity gain after the
signal is below the threshold.
•
Ratio
- The compressor ratio determines the slope in which the signal is
compressed. The higher this value is, the higher the compression.
•
Gain
– The compressor make up Gain. Use it in case the level of the compressed
signal must be corrected (0dB by default)
5.2.7 Limiter
A peak-limiter can be set at each input. It is a zero attack time limiter, so it will
immediately act on the signal. The parameters that can be changed are:
•
Thr.
– Threshold: input level at which the signal will be limited.
•
Rel.
– The release value, expressed in dB/seconds
5.2.8 Phase
– Phase inversion
Change the polarity of the channel by a 180º phase inversion. Select between
Normal or Inverted.
Thr: 12.00dBu
Out12 Limiter
Name
Thr.: 24.00dBu
Out12 Compr.
Att.: 20ms
Out12 Compr.
Hold: 10ms
Out12 Compr.
Ratio: 5.0:1
Out12 Compr.
Rel.: 200ms
Out12 Compr.
Gain: 3.0dB
Out12 Compr.
Rel: 50dB
Out12 Limiter
Name
Normal
Out12 Phase:
Summary of Contents for DSP608
Page 1: ...User s manual DSP608 DSP608D January 2017...
Page 25: ......
