![background image](http://html1.mh-extra.com/html/amano/pioneer-eclipse-pe440st/pioneer-eclipse-pe440st_operators-manual_2918200025.webp)
25
Engine Dust Filter
1. The engine dust filter should be cleaned each hour
and after each use by shaking out the dust and then
rinsing with mild detergent. The filter can also be
vacuumed with a wet-dry vacuum.
2. Squeeze out the excess water
(Do Not Wring)
.
3. Allow the filter to air dry.
NOTE: Failure to maintain a clean engine filter will
cause the engine to overheat. Also, it may cause
the exhaust emissions to elevate to harmful levels. If
necessary, replace with
(Part #: MP373400)
.
Valve Clearance & Re-torque Heads
Refer to Kawasaki’s FS481V service manual.
Valve Seating
Refer to Kawasaki’s FS481V service manual.
Head Bolt Maintenance
Refer to Kawasaki’s FS481V service manual.
Cooling Fin Maintenance
A. Remove blower housing and any other shrouds.
B. Clean the cooling fins as necessary using
compressed air or pressure washer.
C. Reinstall all housings and shrouds.
Inspect Fuel Hose and Connections
1. Push machine to level surface.
2. Turn off LP cylinder and remove it.
3. Remove the hood that covers the battery and
regulator.
4. Inspect hoses for abrasions and other signs of wear.
Replace all worn or damaged hoses.
5. Check for gas leaks by spreading a soapy water
solution around all connections while the LP cylinder
is reconnected and the service valve is turned ON.
5. If a leak is detected, turn off the LP cylinder. If the
leak is in a hose, replace it. If the leak is at a fitting,
loosen and clean it. Apply pipe-sealing compound
and re-tighten it.
6. Recheck for leaks using a soapy water solution. If
leaks persist at fittings, replace them and recheck
with a soapy water solution once more.
Inspect Brushes / Pad Holders
1. Push machine to level surface.
2. Turn off LP cylinder and remove it.
3. Place the machine in the Rok-Bak position (see Rok-
Bak section.)
4. Inspect brushes for loose bolts, cracks, and brush
wear. It is recommended that brushes be replaced
when bristles are worn to 1/2” (1.3cm) length.
WARNING! A damaged brush / pad holder rotating
at a high rate of speed may be an extreme hazard if it
should come apart.
Summary of Contents for Pioneer Eclipse PE440ST
