![background image](http://html1.mh-extra.com/html/amano/pioneer-eclipse-pe440st/pioneer-eclipse-pe440st_operators-manual_2918200016.webp)
16
Rok-Bak
1. Close the valve on the propane cylinder, allow the
engine to stop and turn the machine “
OFF
”.
2. Remove the propane cylinder.
3. Loosen the handle pivot knobs on each side of the
bulkhead.
4. Pull the handle out until it stops.
5. Rotate the handle towards the front of the machine
until it is vertical.
6. Push downward on the handle until it stops.
7. Tighten the handle pivot knobs so the handle cannot
move or slide.
NOTE: The floor stripping machine is heavy and may
require two people to lift and lower the machine safely.
8. Raise the splash skirt around the deck exposing the
deck frame. Use the transport cart pivot arm and/or
the notch in the front of the deck to lift the machine to
a full upright position.
CAUTION! Before lowering the machine back to the
floor, be sure that brushes are attached to the machine
to prevent someone from damaging their hands and/or
fingers. This also will prevent any damage to the head
drive assembly.
9. When lowering the machine down,
DO NOT
drop the
machine. Slowly lower the machine to the floor until
the wheels and brushes are on the ground.
10. Loosen the handle pivot knobs and place the handle
in the operating position. Adjust the handle to the
desired operating position and tighten the handle
pivot knobs.
SafeStop (optional)
SafeStop is a system that monitors the fuel system
and stops engine operation if either an overfilled
cylinder or liquid draw cylinder is used. If SafeStop
is activated, the red LED will illuminate and the
engine will stop operating. If this occurs, remove the
cylinder from the machine, take the cylinder outside,
and verify it is a properly filled vapor draw cylinder.
Note: This system is not a substitute for properly
inspecting propane cylinders prior to bringing inside
a facility. Overfilled or liquid draw cylinders can
damage the fuel system and create a fire hazard.
Refer to the Safety Precautions section in this
manual.
Summary of Contents for Pioneer Eclipse PE440ST
