17
16
EN
Troubleshooting
Drive belts slip.
Insufficient tension.
Tension drive belt.
(Squeaking or squealing sound)
Worn belts.
Replace belts.
Squealing, growling or grinding
Damaged and/or worn bearing.
Remove drive belts, rotate arbor
noise coming from machine.
motor, fan, shafts and idler pulley to
locate dragging or rough bearing.
Contact an authorized American
Sanders dealer.
Dust pick-up is poor.
Dust bag is over 1/3 full.
Empty contents of bag.
Dust bag is dirty.
Shake debris from bag and wash.
Dust chute is obstructed.
Remove fan cover and clear throat.
Motor will not start.
Defective motor starter.
Contact an authorized American
Sanders dealer.
Defective start capacitor.
Contact an authorized American
Sanders dealer.
Defective electronic start switch.
Contact an authorized American
Sanders dealer.
Low voltage from poor connection.
Contact an authorized American
Sanders dealer
Defective motor.
Contact an authorized American
Sanders dealer.
No power.
Check power supply and connections.
Motor runs sluggishly.
Low voltage from excessive footage,
Locate power source nearer to work site.
undersized extension cord, or poor
Decrease sanding pressure.
connection.
Defective run capacitor.
Contact an authorized American
Sanders dealer.
Defective motor.
Contact an authorized American
Sanders dealer.
Motor starter trips/repeatedly
Excessive load.
Contact an authorized American
Sanders dealer.
Defective electronic start switch.
Contact an authorized American
Sanders dealer.
Defective motor starter.
Contact an authorized American
Sanders dealer.
Low voltage from poor connection.
Contact an authorized American
Sanders dealer.
Defective motor
Contact an authorized American
Sanders dealer.
Defective capacitor.
Contact an authorized American
Sanders dealer.
Uneven cut.
Leveling out of adjustment.
Readjust leveling.
Burning or glazing.
Dull abrasive.
Replace abrasive.
Excessive sanding pressure.
Decrease sanding pressure setting.
Too fine of an abrasive.
Use coarser abrasive.
Slow cutting.
Dull abrasive.
Replace abrasive.
Too fine of an abrasive.
Use a coarser abrasive.
Insufficient sanding pressure.
Increase sanding pressure setting.
Waves on sanded surface.
Debris on wheel.
Remove and clean wheels.
Flat spot on tire(s).
Replace tires.
Chatter marks on sanded
Drum out of round.
Contact an authorized American
Surface (close evenly spaced)
Sanders dealer or replace the drum.
Drum vibration.
Change shim combination. Remove debris
from surface or ends of drum.
Problem
Cause
Action
Chatter - Wave Prevention
American Sanders Sanders are designed and manufactured to the most rigid tolerances. However, after a
finishing cut it is possible to see “chatter” or “waves”.
The best guarantee to remove the chatter is to finish the floor with a
rotating horizontal sander, such as American Sanders’s Sander 16.
To minimize chatter when using a belt or drum sander the following steps should be taken:
1) DRUM PAPER...insure the paper is secured in the slot, but not too tight. Paper that
is too tight will force the drum slot wider, leaving a “slot mark chatter” on the floor.
2) DRUM MARKS........are caused by the operator lowering the drum to the floor without forward tra-
verse. These marks should be removed by cutting at a 45 degree angle to the mark. Cutting
at the mark while maintaining the same path will only increase the mark depth and width.