Amadas 2110A, Manual, Page: 31 / 99

2110A PT Peanut Combine Preparation
Pre-Delivery Checks
13. Open cleaning fan adjustment to maximum.
Check to see that the damper door opening
on cleaning fan intake is at least 10-3/8”
inches.
14. Replace or close all shields.
15. Install the PTO driveline and grease. Be
sure to set the tractor hitch ball (or tractor
clevis pin if equipped with pin hitch) at the
specified length from the PTO output shaft
(sketch). The PTO driveline should never
bottom out or overextend while turning.
16. Start the tractor, then engage the PTO and
increase slowly to operating speed (100%
or 790 PTO RPM). Operate for twenty
minutes prior to your first field operation.
17. Stop the combine and check for loose
bolts, nuts, chains, belts, sprockets, etc.
Check for heat in pulleys and belts,
indicating looseness. Also check for
overheated gearbox and hot bearings.
18. Check machine to ensure that all safety
decals are in place.
19. Check tire pressure and inflate tires to
recommended pressure:
Cold inflation pressure:
24 PSI – 24.5 x 32 12 ply (6 row)
[Standard for 6-row dump basket
combine]
26 PSI – 30.5 x 32 12 ply (6 row)
[Standard for 6-row OCS combine;
Optional for 6-row dump basket
combine]
CAUTION
Replace all shields before starting
combine operation. Driveline shields
and guards must be in place anytime the
combine will be in operation.
If shields and guards are not in place,
death or serious injury may result from
entanglement.
10 3/8”
NOTE! 790 PTO RPM is standard for most
machines. Some combines are equipped
with optional drives that require different
input speeds. Refer to the PTO RPM on
your machine.
MAN143 2/29/16 21