Pega 367 with Fanuc 04PC User Pre-installation Guide
©Amada America, Inc.
Print Date 03/07/2001 Revision 4.0
This document available on the World Wide Web at http://www.amada.com
Page 22 of 35
5"
10"
15.8"
Base Plate
Saw Cut Hole In
Existing Floor
Existing Floor
Machine Foot
A
A
A
Machine Frame
Machine Foot
Base Plate
Supplied J-Bolt
4.4"
8.0"
24"
Saw Cut Holes J-Bolt Mounting Method
To maintain machine reliability, extend tool life, and remain level over an extended period the Pega 367 must be anchored in
place on an adequate floor or foundation.
At a minimum the floor must consist of a single, homogeneous slab, level to within 0.032"/ft², and capable of supporting 3.5
tons/ft². It is the purchaser’s responsibility to determine that the floor meets these minimum requirements.
This machine mounting method should be used only if the floor is of such quality that it will support the weight of the machine
with the anchor J-bolts used only for maintaining the location
of the machine.
Please note the following:
!
The base plates, shims, anchor bolts, nuts, and washers
are shipped with the Pega 367.
!
The J-bolt holes should be filled after the machine is placed
on the floor.
!
See special note page 19
Existing Floor
18.701"
37.402"
112.598"
M42 x 630 Anchor Bolt
Pega 367 Centerline
