8
When the Smart or Fast cooling function is enabled, the Vacation function will be disabled automatically.
Smart
When the Smart function is enabled, the temperature of the fresh food compartment is controlled at 5
℃
,
and that of the freezer compartment at- 18
℃
, so that foods can be stored in the best condition while the
refrigerator is running more efficiently and with better performance.
Under the Smart mode, the fresh food compartment temperature and the freezer compartment
temperature are subject to no change.
•
Enabling the Smart function
Press the Function key to select Smart until the corresponding icon gets flickering, and then press the
OK/Lock key within 5s for confirmation. If the OK/Lock is not pressed within 5s, the setting will be
invalidated.
•
Exiting the Smart function
Under the Smart mode, press the Function key to select Smart until the corresponding key gets flickering,
and then press the OK/Lock key for confirmation. The Smart function will be closed.
When the Vacation or Fast Freeze or Fast Cooling function is enabled, the Smart function will be disabled
automatically.
Child Lock
When the Child Lock function is enabled, the temperature and function are subjected to no change to
prevent maloperation. In case of no key operation within 3 minutes, the Child Lock function will be enabled
automatically.
Enabling/exiting the Child Lock function manually: Press and hold down the OK/Lock for 3s, then the Child
Lock function can be enabled/disabled.
Door open alarm
When fridge door is open for more than 3 minutes, buzzer alarms will be continuously issued, which can be
stopped by pressing any key, but will be restored after 3 minutes if the door keeps open. The alarms will not
be lifted until the door is closed.
Power cut memory
In the case of power failure, the refrigerator will maintain the running state that is set before the power
outage.
Power-on delay
In order to protect the refrigerator compressor from being damaged in the case of short-time power failure
(i.e., less than 5 minutes), the compressor will not be started immediately after it is powered on.
Over-temperature alarm (only after power outage)
When the refrigerator system is powered on, if the freezer sensor temperature is higher than -10
℃
, digits of
the freezer zone get flickering on the display. The freezer temperature can be displayed when any key is
pressed, and the normal display will be restored when any key is pressed again or after 10s.
Fault alarm
In case E0, E1, E2, EH, EC or EE is displayed on the operation panel, it indicates fault with the refrigerator.
Please contact the aftersales person for visiting service in such case.
Heater On/Off
First, after keys are unlocked, press and hold down the "Temp. Zone" key for 3
seconds to display “Sd”; 2
seconds later, set the function state to be "On", and wait for 5 seconds to complete the setting. Then, within
5 minutes, hold down the "Temp." key, and then press the "Function" key for 3 seconds to enter the anti-
sweat heater s
etting program. The heater is On by default (with “On” displayed), and you can press the
"Temp." key to switch between "ON" and "OF" at this time.
Instructions for food storage
Precautions for use
•
The appliance might not operate consistently (there is possibility of defrosting or temperature
becoming too warm in the frozen food compartment) when sited for an extended period of time below
the cold limit of the temperature range for which the refrigerating appliance is designed
•
The information of climate type of the appliance is provided on the rating plate.
•
The internal temperature could be affected by such factors as the location of refrigerating appliance,
ambient temperature, and frequency of door open, etc., and if appropriate, a warning that setting of
any temperature control device might have to be varied to allow for these factors should be made.
