WBSn-2400 and WBSn-2450 System Manual
Chapter 3 - Base Station ManagementNetwork
Chapter 3 - Base Station Management
Network
65
1
In the LAN page:
a
In the Common Configuration select the General Setup tab. Change the Protocol to DHCP client
(you will be requested to confirm the action by clicking on the
Switch protocol
button that will
become available).
b
In the Management Interface parameter drop-down list select the Management option.
c
Make sure that the Fallback IP parameters (see
) are configured properly.
d
Click on the
Save
button.
2
In the Common Configuration section of the WAN page, select the Physical Settings tab. In the
Physical Settings tab select the No Interface option.
3
Click on
Save & Apply
to apply the changes.
3.5.1.2.3
Common Configuration
The Common Configuration section is available in all per interface pages.
The Common Configuration section includes the following tabs:
NOTE!
If Hotspot service is enabled (see
“Hotspot General Settings Page” on page 54
, it must be disabled
before starting the process of switching from Router mode to Bridge mode.
