Alvarion 43222600, System Manual

Page: 78 / 129

WBSn-2400 and WBSn-2450 System Manual
Chapter 3 - Base Station ManagementNetwork
Chapter 3 - Base Station Management Network
68
3.5.1.2.3.1.2 DHCP client parameters
The additional parameters available when Protocol is set to DHCP client mode are:
„
Hostname to send when requesting DHCP : The default is the configured device’s Hostname (see
“General Settings” on page 41 ).
„
Accept router advertisements : In the current release the default configuration (checked) should
not be changed.
3.5.1.2.3.2 Advanced Settings
The Advanced Settings tab includes the following components:
„
Use broadcast flag : Available only when Protocol is set to DHCP client mode. When sending DHCP
requests, a client can indicate if it wants an answer in a unicast or broadcast message by setting the
broadcast flag. This may be required for certain service providers. Unchecked by default.
„
Use DNS servers advertised by peer : Available only when Protocol is set to DHCP client mode.
Check (the default) to use the DNS servers settings advertised by the DHCP server.
Figure 3-46: Network Per Interface Page, Common Configuration Section, General Setup Tab
(DHCP client Protocol)
Figure 3-47: Network Per Interface Page, Common Configuration Section, Advanced Settings
Tab (DHCP client Protocol)