Page 17
Set up to detect Voltage (non-contact)
1) Turn the rotary switch to the NCV range;
2) EF is displayed;
3) Place the NCV sensor tip close to the source of electrical energy
being test;
4) If voltage is detected, the Meter will beep and "-" will appear on
the display and the NCV indicator(s) will switch on. The beeping
frequency will increase and the number of "-" will also increase
when higher voltage is detected.
M. RELATIVE MODE
Selecting relative mode causes the Meter to zero the display and store
the present reading as the reference for subsequent measurements.
The Meter is locked into the range selected when you pressed
.
Press
again to exit this mode.
In relative mode, the reading shown is always the difference between
the present reading and the stored reference value. For example, if the
stored reference value is 15.00V and the present reading is 12.10V,
the display shows -2.90V.
