Page 10
1) Turn off power to the circuit being test. Discharge all high voltage
capacitors;
2) Insert the testleads as showing in the above figure;
3) Turn the rotary switch to the Ampere, Milliamp or MIcroamp range;
4) Open the circuit path to be tested and connect the testleads to the
break of the circuit;
5) The measured value shows on the display;
6) If needed, press
to switch to manual ranging, press again to
change the range selected. Hold down the same button to return
to auto ranging.
D. MEASURING AC CURRENT
Warning
• If the fuse burns out during measurement, the Meter may be
damaged or the operator himsel f may be hurt. To avoid possible
damage to the Meter or to the equipment under test, check the
Meter’s fuses before measuring current . Use proper terminals,
function, and range for the measurement . Never place the testing
leads in parallel with any circuit or component when the leads are
plugged into the current terminals.
• When the measured current is between 5A-10A, continuous
measurement 10 seconds and interval more than 15 minutes.
Set up to measure AC Current
