Alto RMX2408DFX, Quick Start Manual

Page: 8 / 60

8
CONNECTION DIAGRAMS
AMP(R) Speakon™ Jack
Speaker
AMP(R) Speakon™ Jack Speaker
Right Speakon
™
Connector to Right Speaker
Left Speakon
™
Connector to Left Speaker
Left Speakon
™
Connector to Right Speaker
AMP(L) Speakon
™
Jack AMP(L) Speakon
™
Jack
Speaker
Right Speakon
™
Connector to Left Speaker
Speaker
™
Jack
Speaker- 4 ohm minimum load
per speaker
Use either the
Speakon™ jacks or
phone jacks
The RMX 2408 is equipped with NL4 type Speakon™ output jacks. When connected to a 4 conductor
speaker wire, 2-Channels of audio can be carried on one cable. NL4 connectors can also be used to
bridge two amplifier channels for mono output.
When using the RMX 2408 in
500W X 2 + 500W X 2 mode, the L and R Speakon™ outputs can be
used to power a stereo pair of speakers per L and R output jack. (In this mode, it is possible to power 2
stereo speaker pairs.)
To drive a pair of speakers at the
L or R Speakon™ outputs, use a Speakon™ NL4 to Speakon™ NL2
splitter cable. The diagram below illustrates Speakon™ splitter wiring.
Note: In 500W X 2 + 500W X 2 mode, the minimum speaker load is 4 Ohms per channel.
AMPLIFER MODE
Speakon
*
4 pole to 2 pole splitter
1+, 1-, 2+,2-
To Speaker Speakon
™
In
Connector
1+,1- (CH -1)
2+,2- (CH -2)
To Speaker Speakon
™
In Connector
From Amp (L)
Speaker- 4 ohm minimum
load per speaker
Main Speaker- 4 ohm minimum
load per speaker
Main Speaker- 4 ohm
minimum load per speaker