Altice Labs D2260G, Manual

Page: 10 / 39

Q
_
P
D
S
_
D
M
_0
9
_V
1
.2
Smart Wi-Fi User Manual
10
Introduction
This User Manual is applicable to the equipment Smart Wi-Fi Altice D2260G with
the FCC ID: 2ACJF-EXT-D2260G
FCC NOTICE
This device complies with FCC part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference, including interference that may cause undesired operation
of the device
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device meets the FCC requirements for RF exposure in public or uncontrolled environments.
RF Exposure Statement
Note: This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
This equipment should be installed and operated with a minimum distance of 7.9 inches (20 cm)
between the radiator and your body.
This system has been evaluated for RF exposure for humans in reference to ANSI C 95.1 (American
National Standards Institute) limits.
The evaluation was based in accordance with FCC OET Bulletin 65C rev 01.01 in compliance with Part
2.1091 and Part 15.27.
The minimum separation distance from the antenna to general bystander is 7.9 inches (20 cm) to
maintain compliance.