Saw blade with stepless cut width RAPIDO
© ALTENDORF 2007
38
Replace scorer saw blades for RAPIDO
Take the adjuster unit off the machine; the clamping
screw may have to be released since a tightened
clamping screw can cause the adjuster unit to jam
on the shaft!
Dismantling:
With hexagonal key:
–
Release clamping screw (1) appr. 3-4 turns, ro-
tate spindle (2) clockwise until the flange (3)
can be pulled away from holder (4)
With Innentorx key:
–
Unscrew screws (5)
–
Remove circular saw blade (6)
–
Fully clean flange (3) and screws (5). The run-
ning and flange surfaces must be clean and
dust free.
–
Fit a new circular saw blade, note direction of
rotation and arbor image when fitting: The cir-
cular saw blade (6) lies flat on the flange (3) and
the protrusion on the circular saw blade points
to the contact surface
–
Screw in screws (5) and tighten to a torque of
8,6Nm
–
Proceed in the same way with the other half of
the adjuster unit
Assembly:
Do not oil or grease!
–
Clamping screw (1) is released
–
Fit the flange (3) vertically on to the holder (4)
so that the spindle (2) engages in the threaded
hole (7)
–
Use the hexagonal key to turn the spindle (2) in
a counterclockwise direction. The flange (3) will
be pulled into the holder (4) no additional force
may be used here
–
Continue to turn spindle (2) until the two halves
of the circular saw blade are lying against each
other
–
Install the adjuster unit on the machine
–
Setting the cutting width, see above
–
Only turn clamping screw (1) slightly
