Machine operation
© ALTENDORF 2007
27
7
Machine operation
7.1
Adjustment of the main saw blade
Fig. 7-1: Control System
Cutting height adjustment
Tilt adjustment
Rise and fall adjustment
–
The cutting height is reduced by pressing the
-
key.
–
The cutting height is increased by pressing the
+
key
–
When the Plus key or the Minus key are held
down the saw blade moves for 2 sec. in
creep mode and then switches automatically to
fast mode
Tilt adjustment
–
The angle of tilt is reduced by pressing the
0°- key.
–
The angle of tilt is increased by pressing the
45
°
key
–
When the 0° key or the 45° key are held down
the saw blade moves for 2 sec. in creep mode
and then switches automatically to fast mode
–
Tapping the 0°/ 45° keys briefly makes an ad-
justment of 0.1° in each case!
Calibrating the tilt angel display
–
Tilt the saw blade into the vertical position and
check the 90° angle
–
Press the RESET key for 3 seconds, the dis-
plays shows 0, the machine is calibrated
Calibrating the tilt angel display
–
Clear the main table of any workpieces in the
tilting area
–
Move the scale of the rip fence into the flat po-
sition for a cutting width <130 mm!
