Assembly
© ALTENDORF 2007
19
5
Assembly
5.1
Setting up the sliding table saw
Foundation
No special foundation is required at the installation
site for the sliding table saw. The floor must have
suitable load bearing capacity to take the weight of
the machine, it must be even and level. If the ma-
chine rocks this should be remedied by putting a
machine foot underneath it.
Installation site
The installation site for the machine should be se-
lected so that, taking into account its space require-
ments and the size of the workpieces to be
handled, sufficient free space is available around
the sliding table saw. In addition the appropriate
safe distances from parts of the building and from
other machines are to be adhered to so that there
is no danger to the operator or to others of being
trapped.
5.2
Sliding table assembly
–
Place the carriage on the machine stand and
secure it with the outer securing screws. Before
tightening the screws push against the stop
screws!
–
Place the middle carriage on the bottom car-
riage so that the interlock is pointing to the right.
–
Push the middle carriage to the right so that the
1st double roller is still just resting on the round
bars.
–
Carefully push on the top carriage making sure
it is not skewed, watch the e-chain and
carefully push the guide rails onto the double
rollers
–
Push the top carriage towards the left, all the
way to the stop.
–
Fit the back stop and check whether the stop on
the top carriage and the stop on the bottom
carriage hit the end position at the same time.
Adjust if necessary
–
Before putting into service check the adjust-
ment of the lower rollers
5.3
Installation of table length
extension
–
Guide the pins of the table length extension into
the holes on the face of the table plate
–
Secure loosely to the table plate with two M10
nuts and shake proof washers
–
Tighten the M10 nuts
5.4
Installing the safety hood
–
Push the safety hood support onto the attach-
ment bolts
–
Put on shake proof washers and secure with
nuts
