Alstom MiCOM P54 Series, Technical Manual

Page: 167 / 1024

Settings P54x/EN ST/La4
MiCOM P543, P544, P545, P546
(ST) 4-89
ST
Instead of operating the control inputs as described in d also be
set to re-define n. This is g in y
menu. The operating mode for each of the 32 Contr ts can b dividually.
nge Step size
1.4.12 Control input configuration
the above section, they coul
achieved by mappin perform a p d control functio the Hotke
ol Inpu e set in
Menu text Default setting Setting ra
CTRL I/P CONFIG.
Hotkey Enabled 11111111111111111111111111111111
Setting to allow the
setting ‘1’ in the ap con s to be individually assigned to
ey
menu by
prop n the
Hotkey Enabled
cell. The u
trol input
riate bit i the
Hotk
hotkey men allows the
control inputs to be set, reset or pulsed without the need to enter the
CONTROL INPUTS
column.
Control Input 1 Latched Latched, Pulsed
Configures the control inputs as either ‘latch
remain in the set state until a reset comman ed’ or ‘pulsed’. A latched control input will
d is given, either by the menu or the serial
wever, will remain energized for 10 ms after
et automatically (i.e. no reset command
communications. A pulsed control input, ho
the set command is given and will then res
required).
Ctrl Command 1 Set/Reset
Set/Reset, In/Out, Enabled/Disable , d
On/Off
Allows the SET / RESET text, displayed in the hotkey menu, to be changed to something
h as
ON / OFF
, more suitable for the application of an individual control input, suc
IN / OUT
etc.
Control Input 2 to 32 Latched Latched, Pulsed
Conf ntrol in ched’ o igures the co puts as either ‘lat r ‘pulsed’.
Ctrl Command
2 to 32
Set/Reset
Set/Reset, In nabled/Disabled, /Out, E
On/Off
Allows the SET / RESET text, displayed in the hotkey menu, to be changed to something
e for the on of an individual control input, such as
ON / OFF
,
.
more suitabl
IN / OUT
etc
applicati
1.4.13 F
Setting range
unction keys
Menu text Default setting
Min. Max.
Step size
FUNCTION KEYS
Fn. Key Status 0000000000
Displays the status of each function key.
Fn. Key 1 Status Unlock/Enable Disable, Lock, Unlock/Enable
Setting to activate function key. The ‘Lock’ setting allows a function key output that is s
to toggle mode to be locked in its current active state. et
Fn. Key 1 Mode Toggle Toggle, Normal
Sets the function key in r normal mo ‘Togg a sing press will
. This
function
key output will remain ‘high’ as long as key is pressed.
toggle o de. In le’ mode, le key
set/latch the function key output as ‘high’ or ‘low’ in programmable scheme logic
feature can be used to enable/disable relay functions. In the ‘Normal’ mode the
Fn. Key 1 Label Function Key 1
Allows the text of the function key to be changed to something more suitable for the
application.