11
Subject to change without notice | 83057200dUK – Translation of the original operating manual | ait-deutschland GmbH
6 Installation and connection
6.1 Dismantle the module box
ATTENTION
If the module box is tilted by more than 45°,
compressor oil runs into the cooling circuit.
Ź
Do not tilt the module box by more than 45°.
NOTE
Ɣ
If necessary the module box can be
dismantled for easier transport of the unit
or for service reasons.
Ɣ
Steps 1 to 5 are only required if the module
ER[LVFRQQHFWHGDQG¿OOHG
9
Unit is safely disconnected from the power supply
DQG SURWHFWHG DJDLQVW EHLQJ VZLWFKHG EDFN RQ
again.
1. Remove the front panel of the module
ER[
Æ
“7.1 Remove the front panel of
WKHPRGXOHER[´SDJH
2.
&ORVHVKXWRႇYDOYHVWRWKHKHDWLQJFLUFXLW
3.
'UDLQ WKH XQLW YLD WKH ¿OOLQJ DQG GUDLQ WDS RI WKH
heating.
NOTE
The hose connectors are not part of the
scope of delivery with all KFE ball valves.
4.
8VHDVSDQQHUWRFORVHWKHVKXWRႇYDOYHVRIWKH
KHDWVRXUFHEHKLQGWKHFRYHUV
5.
'UDLQ WKH XQLW YLD WKH ¿OOLQJ DQG GUDLQ WDS RI WKH
heat source.
6. Disconnect the electrical connections:
Ɣ 'LVFRQQHFW ZKLWH FRQQHFWRUV DW WKH ERW
-
tom of the electrical control cabinet. To do this,
release the lugs by pressing on the sides of
the connectors
Ɣ 3XOORXWWKHEODFNUHFWDQJXODUFRQQHFWRUDW
the top of the module box
