02
IMPORTANT SAFETY INSTRUCTIONS
1. Do not install or use the product in wet places as steam room etc.
2. It is recommended to use water-proof electrical outlet which should be installed in a
place where is not easily to get wet.
3. This product should be used with 110V-120V, 50/60Hz electrical current only, load
current is at least 15A. Power plug must be equipped with ground fault circuit
interrupter or ground fault electrical leakage protector or similar high sensitive,
rapid type leakage switch
(Rated sensitive current under 6mA).
4. When it thunders, it is strongly recommended to pull out the power plug.
5. Do not use bleach, ammonia, or alcohol based chemical cleaners (most bathroom
cleaners) on the bidet seat. This will result in discoloration and cracks over time.
6. Ceramic toilet must install floor fixing bolts.
7. Do not stand on ceramic toilet, seat, or lid.
8. Do not lean against the lid when using the product, to avoid damage.
9. This product is equipped with a soft-closing seat and lid. Do not push the toilet seat
closed, or damage may occur.
10. Do not use any caustic chemicals or abrasive brusher to clean this product.
11. Exposure to direct sunlight is prohibited.
12. Only use tap water or potable water, otherwise it may cause chafing.
13. Do not connect water supply to heater outlet. Make sure inlet water temperature is
between 3~35
℃
/
3 7.4~95
℉
14.When the room temperature is under zero degree, please drain the water tank, to
avoid freezing.
15. Raise room temperature to prevent the toilet from damage due to freezing.
16. When moving the product from cold or wet environment into normal room
temperature, wait for 2 hours until the condensation water is fully volatilized. Doing
so can prevent the product from electrical short-circuit.
17. When not using the product over three(3) weeks, drain the water out of the toilet
and pull the electrical plug from the wall outlet.
18. Stop using the product and shut off the power when product malfunctions. Call for
professional service.
CAUTION
–
Indicates that failure to follow the instruction may cause body injury or
property damage.
GROUNDING INSTRUCTIONS
This product should be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current.
This product is equipped with a cord having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly installed and grounded.
DANGER –
Improper use of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding
wire to either flat blade terminal. The wire with insulation having an outer surface that
is green with or without yellow stripes is the grounding wire.
This product is factory equipped with a specific electric cord and plug to permit
connection to a proper electric circuit. Make sure that the product is connected to an
outlet having the same configuration as the plug. No adapter should be used with this
product. Do not modify the plug provided — if it will not fit the outlet, have the proper
outlet installed by a qualified electrician. If the product must be reconnected for use on
a different type of electric circuit, the reconnection should be made by qualified service
personnel.
SAVE THESE INSTRUCTIONS
Summary of Contents for UX-T Pearl
Page 1: ...UXT Pearl...
Page 20: ......